Problem 1.1. Create an orthographic drawing of a rectangle that is 4” wide by 5” long and .5” thick.2. Within the first rectangle, create a second rectangle that is 2”wide 3” long. Offset this rectangle from one of the longer sides on the original rectangle by .25”. This rectangle should have a depth of .25 from the surface of the first rectangle.3. To the second rectangle add a fillet/round at all its vertices. Make the radius for all .125”4. Below of above the second rectangle that you just created input the letters “ISU” and make sure they are centered. All lettering should have a depth of .35”5. Within the second rectangle place your initials. Use punctuation marks for your initials and make them the same depth as the letters.6. Create an internal rectangle within the first rectangle that is .25 away from it all round. 7. Make all corners have a fillet with a radius of .125”.8. Save your fileFor this problem we will ultimately be creating a tooling paths to machine a part that is .7” thick.
Problem 2.1. Create an orthographic drawing of a cylinder that is 1.5” in diameter and 5” in length. Within the first cylinder, create a second cylinder that has a diameter of .5” and a length of 1”. A whole that is drilled into the top of the cylinder (Internal diameter .5”). 3. The cylinder should have three external diameters. The first diameter should be 1.15” and should be two inches in length. The second should be 1.25” in diameter and should be 1” in length and the final diameter should be 1.5” and 2” in length.4. Save your file.

Need help with this Essay/Dissertation?
Get in touch Essay & Dissertation Writing services