After reading the National Security Strategy (2017)
Below is the Link:
https://www.whitehouse.gov/wp-content/uploads/2017/12/NSS-Final-12-18-2017-0905.pdf
Should the United States create a separate cybersecurity strategy to be published alongside the National Security Strategy (NSS), or do you feel the NSS is sufficient? Why or why not?
Sample Solution
prepared nanoparticles of Eudragit L100-55 using nanoprecipitation method to determine effect of polymer concentration on nanoparticle size using different organic solvents and he found that in all cases, increasing polymer concentration in organic phase resulted in increasing mean size [149],and D. Quintanar-Guerrero et al., 1999 [215] who used emulsion-diffusion method to prepare Eudragit E nanoparticles using Eudragit E/ethyl acetate/PVAL system and cellulose acetate phthalate (CAP) nanoparticles using cellulose acetate phthalate/2-butanone/Poloxamer 407 system and in two systems it was found that there is a switch between micro and nanoparticles depending on polymer concentration in internal organic phase where, as polymer concentration increased, size of produced particles significantly increased [215]. On the other hand, these results are disagreeing with those reported in Ahmed, I.S., et al.,2014 [216] who prepared poly-Æ- caprolactone nanoparticles by solvent displacement method and investigated the effect of polymer concentration on particle size. It was found that increasing polymer concentration from (0.5 to 0.8% w/v) at surfactant concentration (0.5% w/v) resulted in increasing particle size while, at the same surfactant concentration and increasing polymer concentration to (1% w/v) particle size decreased. Also, increasing polymer concentration from (0.5 to 0.8% w/v) at surfactant concentration (1% w/v) resulted in decreasing particle size while, at the same surfactant concentration and polymer concentration was increased to (1% w/v) particle size increased. These results were attributed to that at low polymer concentration and high surfactant concentration, the solubility of polymer in acetone/water mixture might have increased due to the solubilizing effect of the surfactant leading to slower rate of polymer precipitation and formation of larger particles. While at higher polymer concentration the effect of surfactant on solubility was less marked leading to higher precipitation rate and the formation of smaller particles [216]. The higher polymer concentration might also results in increasing viscosity of the organic phase, which might decrease the diffusion rate and might lower the rate of Ostwald ripening for >
prepared nanoparticles of Eudragit L100-55 using nanoprecipitation method to determine effect of polymer concentration on nanoparticle size using different organic solvents and he found that in all cases, increasing polymer concentration in organic phase resulted in increasing mean size [149],and D. Quintanar-Guerrero et al., 1999 [215] who used emulsion-diffusion method to prepare Eudragit E nanoparticles using Eudragit E/ethyl acetate/PVAL system and cellulose acetate phthalate (CAP) nanoparticles using cellulose acetate phthalate/2-butanone/Poloxamer 407 system and in two systems it was found that there is a switch between micro and nanoparticles depending on polymer concentration in internal organic phase where, as polymer concentration increased, size of produced particles significantly increased [215]. On the other hand, these results are disagreeing with those reported in Ahmed, I.S., et al.,2014 [216] who prepared poly-Æ- caprolactone nanoparticles by solvent displacement method and investigated the effect of polymer concentration on particle size. It was found that increasing polymer concentration from (0.5 to 0.8% w/v) at surfactant concentration (0.5% w/v) resulted in increasing particle size while, at the same surfactant concentration and increasing polymer concentration to (1% w/v) particle size decreased. Also, increasing polymer concentration from (0.5 to 0.8% w/v) at surfactant concentration (1% w/v) resulted in decreasing particle size while, at the same surfactant concentration and polymer concentration was increased to (1% w/v) particle size increased. These results were attributed to that at low polymer concentration and high surfactant concentration, the solubility of polymer in acetone/water mixture might have increased due to the solubilizing effect of the surfactant leading to slower rate of polymer precipitation and formation of larger particles. While at higher polymer concentration the effect of surfactant on solubility was less marked leading to higher precipitation rate and the formation of smaller particles [216]. The higher polymer concentration might also results in increasing viscosity of the organic phase, which might decrease the diffusion rate and might lower the rate of Ostwald ripening for >
